BIONIZER CONTROL BOX INSTALLATION
POWER
INPUT
LEAD
IONIZING
OUTPUT
LEAD
12V DC
OUTLET
SOCKETS
MAINS
POWER
OUTLET
MAINS
POWER
OUTLET
10
INSTRUCTION BOOK
CONTROL BOX INSTALLATION
1. Make sure that the Control Box is positioned near
enough to a power outlet and to the BioPod Cartridge
to allow the power connecting and anodes cables to
reach the socket and BioPod Cartridge.
2. Choose a position that will allow you to see the LCD
(Display) easily. Fix the control box in position using
screws at each corner of the box.
3. Make sure (if possible) that the unit is undercover and
that the LCD (Display) is not in direct sunlight as it is
not covered by warranty if it is damaged by sunlight.
4. Once fixed in position attach the connecting wires to
the anode connectors and tighten the wing nuts onto
each connector. It does not matter which connector
goes on which anode.
5. Plug the pump power cable into either of the outlet
sockets at the base of the control box.
The spare mains power outlet can be used for any
mains powered device that will operate whenever the
pool pump is running. The AC/DC adaptor of a pH
BOSS or Eco-Oxidizer can be connected here.
6. Two 12V DC outlets are provided for powering a pH
BOSS and an Eco-Oxidizer. Connect the short DC-DC
Adaptor Cable supplied for this purpose. These units
will thereby only operate when the pool pump is
operating.
DO NOT
connect any other 12V DC device to the 12V
DC power outlets. Damage from connecting non-
genuine accessories is not covered by your warranty.
7. Lastly, plug the power cable for the Bionizer unit into a
power source.
For low tariff power installations where the Control
Box will be hard wired to the power source, a licensed
contractor will be required.
Your Bionizer is now ready for programming.
MAXIMUM COMBINED OUTPUT FOR BOTH POWER OUTLETS IS 9.5 AMPS (2280 WATTS).
CONNECTING MORE LOAD THAN THIS WILL CAUSE THE INTERNAL CIRCUIT BREAKER TO TRIP.
