5.2 Carry out calibrations and controls
To carry out the calibrations, enter the calibration menu. Then select the tests one by one, or click
import the tests from the current patients list.
Then click on
The following window appears:
•
You can “Delete Standards” to
run the controls against factors
only
•
“Delete controls” to run only
calibration without any control
•
Modify Standards concentrations.
In this case, the concentrations of
standards will automatically be
updated
in
the
concerned
methods.
•
Modify Factor: to adjust the factor
for kinetics. For End points or
Initial rate, the factor can only be
adjusted
if
the
standard
concentration is “0”.
When the tests are ready, click on
In the Start menu (
), you can see the prog
column.
N
N
o
o
t
t
e
e
: It is possible to run only the calibrations, o
run calibrations and patients’ analyses together.
See 6.5.4 Start the run page - 46 -
Carry out calibrations and controls
To carry out the calibrations, enter the calibration menu. Then select the tests one by one, or click
import the tests from the current patients list.
You can “Delete Standards” to
against factors
“Delete controls” to run only
control
Modify Standards concentrations.
In this case, the concentrations of
standards will automatically be
updated
in
the
concerned
to adjust the factor
For End points or
Initial rate, the factor can only be
d
if
the
standard
), you can see the programmed calibrations. They are tagged
: It is possible to run only the calibrations, or to
analyses together.
N
N
o
o
t
t
e
e
: If an automatic predilution of the standard is
possible (according to the values indicated in the
methods menu), the button Build curve
available. Click on it to perform the autom
predilution of the standards.
standard at the indicated position.
- 32 -
To carry out the calibrations, enter the calibration menu. Then select the tests one by one, or click on
to
rammed calibrations. They are tagged by a “C” in the right last
: If an automatic predilution of the standard is
possible (according to the values indicated in the
methods menu), the button Build curve
is
available. Click on it to perform the automatic
predilution of the standards. Insert the concentrated
standard at the indicated position.
Содержание KENZA 240 TX
