VI.c)
Valve settings
The module fitted in ST-560 controller regulating the mixing valve. For control valves (e.g. ST-431N), it is possible
to connect two additional modules. The interval of parameters allows the user to adjust the performance of the valve
according to the individual needs. When a specific valve is activated, the monitor shows additional menu where it is
possible to configure valve parameters.
The parameters of both installed valves and additional valve are similar as provided in the flowcharts:
•
Installed valve
•
ON
•
Valve disconnected
•
Pre-set valve temperature
•
Opening time
•
Type of valve
•
CH
•
floor
•
Room regulator
•
Control without room regulator
•
RS regulator - reduction
•
RS regulator - proportional
•
Standard regulator
•
Room reg. temperature is lower
•
Room regulator CH pump
•
Valve closing
•
Air basis control
•
Valve pump
•
Always turned on
•
Always turned off
•
Turned on above the threshold valve
•
Turn on the temperature
•
Reverse flow protection
•
ON
•
OFF
•
Minimum temperature
•
CH boiler protection
•
ON
•
OFF
•
Maximum temperature
•
Opening direction
•
Left
•
Right
•
Single stroke
•
Minimum opening
•
Proportionality coefficient
•
CH sensor option
•
CH sensor
•
Additional sensor 1
•
Calibration
•
Measurement stopping
•
Factory settings
•
Additional valve 1, 2
•
Registration
•
Valve disconnected
•
Pre-set valve temperature
18
