Bio-Tek FL600, Руководство по оборудованию

Страница: 34 / 57

Bio-Tek FL600 3-9
NOTE 2: Exposing the inside measurement chamber to ambient light
for more than 30 minutes may cause saturation of the measurement
device. Should this occur, please wait 24 hours before reading.
Step 3: Reaching into the inside of the instrument, place a microplate on
the plate carrier, ensuring that it is the same type you usually use.
Step 4: Place the probe height adjustment shim (provided in the
accessories box) on the top of the plate, taking care to center it over
the plate. The end that contains the notch matching the top probe
size must be oriented toward the optical probe.
Step 5: Using the 2.5 mm hex wrench provided, loosen the two set screws
holding the top probe in place. These two set screws are located on
the front surface of the top probe.
Step 6: Carefully raise the probe so that the bottom of the top probe is
above the top edge of the plate and shim on the plate carrier.
Step 7: Turn the X-axis and the Y-axis drive screws so that the appropriate
notch in the shim is located underneath the top probe.
Step 8: Carefully lower the top probe into the notch of the shim, taking
care not to damage the probe. Make sure that the probe is straight
and vertical, and then tighten the set screws.
Step 9: Turn the X-axis drive screw so that the plate is no longer located
under the probe. Make sure that the plate carrier has not traveled
so far as to open the door. If it has done so, back the plate up by
turning the X-axis screw.
Step 10: Remove the microplate and shim from the plate carrier.
Step 11: Replace the top cover. Carefully align the five 4 mm screws
holding the top shroud in place, and then tighten them.
Step 12: Check the door for ease of movement. If the door movement is
impeded, try readjusting top shroud, making sure that it is on
properly and that the screws are tightened sufficiently.
Step 13: Attach the power cord, and turn on the power switch. The plate
carrier should eject.