Note
Before you continue, please ensure that all access points that the WLAN controller
shall manage are correctly wired and switched on.
11.1.4 Start automatic installation
You will see a list of all detected access points.
If you wish to change the settings of a detected AP, click on
in the corresponding entry.
You will see the settings for all selected access points. You can change these settings.
The following parameters are available in the Access Point Settings menu:
Location
Displays the stated locality of the AP. You can enter another locality.
Assigned Wireless Network (VSS)
Displays the wireless networks that are currently assigned.
The following parameters are available in the wireless module 1 menu:
(The parts wireless module 1 and wireless module 2 are displayed if the AP has two wire-
less modules.)
Operation Mode
Select the mode in which the wireless module is to be operated.
Possible values:
•
-
(default value): The wireless module is used as an access point in your network.
•
-$$
: The wireless module is not active.
Active Radio Profile
Displays the wireless module profile that is currently selected. You can select another wire-
less module profile from the list if more than one wireless module profile are being set up.
Channel
Displays the channel that is assigned. You can select an alternative channel.
bintec elmeg GmbH
11 Wireless LAN Controller
bintec RS Series
171
