BinTec BIANCA/BRICK-XL2, Начало работы

Страница: 12 / 36

BIANCA/BRICK-XL2
6
your power source. You may decide to wait until you’re
ready to access the BRICK before connecting the power
source.
LED Indicators
Each time you power up the system, the BRICK switches
into
Power Up Mode and performs a self-test to verify the
integrity of the system. The LEDs on the front panel cor-
respond to various stages of the test.
Upon successful completion of the self test, the BRICK
then switches into BOOTmonitor Mode , (all LEDs re-
main on) as described in the User’s Guide.
If the ERR indicator remains on (see table below) there
may be a problem with the cabling. Verify the ISDN and
LAN cabling is correct and power up the system again.
Also note that the once the rooter is up, the system may
be accessed via the ISDN using the factory-set passwords.
Changing the default passwords is described on page 15.
After 4 seconds, the system then switches into Normal
Operation Mode . During normal operation, the front
panel indicators display status information as follows.
LED State Meaning
PWR On
Power:
Power is being supplied.
S1 - S7 –
The meaning of these LEDs depends
on the type of module installed in the
corresponding slot.
A detailed description can be found
in the BIANCA/BRICK-
XL2
User’s
Guide.
☞
☞