BinTec BIANCA/BRICK-XL2, Начало работы

Страница: 24 / 36

BIANCA/BRICK-XL2
18
Setting up the ISDN Interface
Select [ CM-2BRI, ISDN S0, Unit 0 ] to configure your ISDN
interface. Note that you can configure your ISDN inter-
face either as an ISDN dialup line or as a leased line. Since
the menu entries differ slightly depending on what type
of ISDN line you are using, continue with the configura-
tion by performing the appropriate section as follows:
• For a Dialup Line configuration, refer to pages 18 - 24.
• For a Leased Line configuration, refer to pages 24 - 27.
Dialup Line
Depending on which protocol your ISDN subscriber in-
terface uses and whether or not the ISDN autoconfigura-
tion was successful, the [
CM-2BRI, ISDN S0, Unit 0 ] menu
may be displayed as follows:
The ISDN autoconfiguration procedure runs until ei-
ther the proper protocol is detected or the switch type is
set manually. If the cables are connected and auto detec-
BIANCA/BRICK-XL2 Setup Tool BinTec Communications AG
[SLOT 2 UNIT 0 ISDN BRI]: Configure ISDN Basic Rate Interface mybrick
Result of autoconfiguration: Euro ISDN, point to multipoint
ISDN Switch Type autodetect on bootup
D-Channel dialup
B-Channel 1 dialup
B-Channel 2 dialup
Advanced Settings >
Incoming Call Answering >
SAVE CANCEL
Use <Space> to select