Biketec AG Flyer, Руководство по эксплуатации

Страница: 23 / 94

19
This unlocks the battery, which can subse-
quently be removed from its holder.
It is removed by tipping it outwards at approx.
45° and then lifting it diagonally upwards.
8.1.2 Charging the battery
Caution: The charger for
your battery contains
specific instructions
which you should first
read and take note of.
First, remove it from its
packaging and place the
battery within it in the
same way as you removed it from the FLYER.
Then connect the charger to a mains socket
(observe type plate, 230 V). Select a suitable
location for charging. This should be dry, stable
and flat. Do not cover the battery during charg-
ing as the process generates heat which has to
be able to escape.
When the charging pro-
cess begins, the light diodes,
called LEDs here, light up on
the battery. The battery is only
completely charged when all
5 LEDs have gone out.
If your FLYER has an op-
erating voltage of 36 V, the
charger will display any error
which could have occurred.
If you have acquired
a speed pedelec with
an operating voltage
of 36 V, the charger
shows the current
status (including possible errors) using a num-
ber of different LEDs. The red and the green
LEDs on the charger light up or blink in a cer-
tain combination.
Be careful, the battery is heavy. Hold on to it
tightly when you tip and remove it from your
FLYER. It is a good idea to remove the key af-
ter doing this and keep it safe, so that it is not
damaged or lost.
Info
Mode Red LED Green LED
Battery NOT
connected/no
contact
NO lights NO lights
Battery
management
identifies the
battery
NO lights
Blinking
(1Hz)
Charging
process
NO lights Constant
Fully charged NO lights NO lights
Battery
management
is waiting for
a command
NO lights
Blinking
(1Hz)
Error
message
Blinking
(2Hz)
NO lights