2
2
Figure 6:
Controller within Bracket
4. Close the bracket and tighten the closure screw securely.
Connecting the Heater’s Wire to the Pins:
20-14 AWG Wire
Insulation Support Barrel
Body of Pin
Wire Barrel
Figure 7:
Diagram of Pin and Stripped Wire
1. For heater’s power leads use the bronze pins. If the heater has a
ground wire, then use the silver pin for the ground wire.
2. Strip off enough insulation to uncover the length of wire needed
to fit the pin’s wire barrel (approximately 1/8”).
3. Use a crimp tool to crimp the insulation support barrel to the
insulated wire. (To order a crimp tool see page 24).
4. Crimp the wire barrel around the uninsulated wire.
