Beta Enduro RR 350 2013, Руководство по ремонту

Страница: 76 / 134

2
74
E
N
G
IN
E ASS
E
M
B
LY AN
D CO
NTRO
LS
ASSEMBLY OF LOW PRESSURE
PUMP
Insert the internal rotor 1 on the shaft 2 so
that the dot on the face of the rotor faces in-
wards. Then insert the roller 3 on the shaft.
Use motor oil to lubricate the seat of the
rotors on the outside of the crankcase half,
insert the external rotor 4 and the internal
shaft-rotor unit in its proper seat.
Insert the ball 5 (diameter 5.5mm) and the
respective compression spring
6
.
Lubricate with motor oil and, while rotating
the protruding segment of the drive shaft
(from the outside of the right crankcase
half), make sure it rotates freely and does
not jam.
Fasten the cover 7 to the crankcase with the
three screws 8 , which must first be spread
with medium strength threadlocker. These
screws must be tightened at a torque of
6Nm.
2
.11 .1
Shaft, low pressure pump, internal rotor and roller
unit.
Complete low pressure pump coupled to the crankca-
se.
Coupling low pressure pump cover to crankcase.
1
4
5
6
2
3
7
8
6Nm