34
Overlock threading
Re-threading or changing threads
If spools are empty or you
want to change the thread, it
is not necessary to re-thread
the machine.
Simply cut off the threads
above the cones or spools,
replace them and knot new
Needle L
(yellow markings)
Place the spool on the spool
pin as illustrated.
thread on to the existing
thread. Cut the threads off
at the needles. Raise the
presser foot, pull the threads
through and re-thread the
needles. Pull the looper
threads through using the
1. Bring the thread up from
the spool and lay it from
the back to the front into
the guide.
2. Thread the first thread
guide.
3. Slip the thread through
the groove.
4., 5., 6. Take the thread
under the thread guide
plate, through the take
up and into the guide.
7. Thread guide on the
needle clamp.
8. Thread needle
L
from
front to back and lay the
thread to the left under
the foot.
After threading
When threading is complete,
lower upper knife (if raised),
close the looper cover (place
waste collector in position).
existing thread chain. Some
thick decorative threads
cannot be pulled through the
looper eyes. Lower the
presser foot. Select the stitch
of your choice and test sew.
1
2
2
3
4
7
8
6
8
5
2500_DCE_1_englisch_neu 09.10.2007 14:35 Uhr Seite 34
