Bergen INTREPID GAS, Руководство пользователя, Страница: 46 / 151

This is a good time to install the on/off switch, elevator, and throttle servos. It’s
a good idea to install the switch with the OFF side up, to prevent an accidental
shut off in the event of a hard landing.
In Bag 11 you will find the plastic servo mount tabs used in place of nuts and
eyelets when installed into the rubber grommets of the servos. Insert the LONG
end of the tab into the grommet.
Place the servos into the frames, splined shaft to the rear, from the INSIDE, and
secure with the preferred screws. If using JR servos, the supplied self tapping
screws work just fine. If using Futaba servos, ask us for a set of 2.5X8 mm
SHCS and 2.5mm washers, as the Futaba screws are just too small in diameter to
properly secure the servos.
Center the servo in the hole, and do NOT crush the rubber grommets with
excessive torque when tightening the screws. Remember they are supposed to
isolate the servo from any vibes.