Bergen INTREPID GAS, Руководство пользователя, Страница: 142 / 151

Place a small drop of loctite on the threads of the shoulder bolt and screw into
the horn on the tail blade grip, being VERY careful NOT to get loctite into the
joint. This will make the joint stiff and your tail rotor system will NOT function
properly, causing servos to overheat, tail wags, sticking, etc.
The tail blade grips and associated hardware must be installed in the proper
order for proper operation, note the 10mm OD spacer installed BEFORE the
thrust bearings. Also be sure to grease the ball cage of the thrust bearings.
One of the thrust bearing washers has a smaller inner diameter than the other,
you can identify it by placing them onto the tail rotor hub, noting which one is
tighter on the shaft.