26
EXCLUSIVE
- setting TIME and DATE
TIME & DATE
ENTER TIME AND DATE
12
:
17
18 / 11 / 2013
USE THE ARROWS TO MODIFY
- Select CONFIRM to conform the system reset or else CANCEL to
cancel the operation.
CONFIRM
CANCEL
Note:
after a reset it is necessary to carry out a new configuration of the
system; for details about this procedure, see the following section.
5.20
System Re configuration
( after Reset)
This operation must be carried out only by a competent engineer
MULTI ZONE CONTROLLER
REC10 V01.26
PRESS ANY KEY
TO CONTINUE
- LANGUAGE selection:
ENGLISH
ITALIANO
-
Setting the operating mode of the REC10:
Select MASTER when a replacement REC10 is the integral boiler interface
-
Configuration selection:
Use
NEW
: to set a new system configuration if restoring the factory
setting of the parameters
SELECT THE TYPE
OF CONFIGURATION
FROM AKM
NEW
With “NEW” configuration selected, proceed as follows:
- select REC10 functionality:
Select ON BOARD: The REC10 is used as a system interface and not as
A Zone regulator
AMBIENT: used only if another REC10 is used as a separate system
interface as an ambient regulator of the zone to which it is installed
BOILER
WHERE IS
THE REC10 INSTALLED?
ON BOARD
AMBIENT
- Select the type of boiler =INSTANTANEOUS (the boiler is the combined
heat and hot water variety)
ENGLISH
ITALIANO
PLANT
CH ONLY
INSTANTANEOUS
STORAGE TANK
SELECT THE PLANT
CONFIGURATION
INSTALL
ZONES MANAGER
SENSOR CALIBRATION
SYSTEM RESET
INSTALLER
After a “SYSTEM RESET”, the control displays an initial screen
showing the firmware revision. Pressing
“ok”
a guided procedure is
started for configuring the system; select the desired options with the
“up”
and
“down”
keys, confirming the selections made:
Содержание EXCLUSIVE 25C
Страница 43: ......
