Bercomac 700968-1-33V, Руководство пользователя

Страница: 27 / 60

Maintenance & Lubrication
25
Maintenance procedures
Auger and fan shear bolt replacement
IMPORTANT: The shear bolts are to be considered a
preventive measure and not an assured protection. Operator
vigilance is required. Thoroughly inspect the areas where the
snowblower is to be used and remove all foreign objects.
TO AVOID DAMAGE TO THE SNOWBLOWER:
Use only the original shear bolts
(#105627 for the fan et #106443 for the auger).
The use of any other shear bolt will not insure any protection
and may void the warranty.
IMPORTANT: When replacing the auger shear bolts it is very
important to replace the augers in the same position as
shown in figure to avoid damage to the snowblower and to
ensure maximum efficiency.
Belt replacement:
For belt part number, refer to parts breakdown section for
parts identification.
a) Remove the belt guard (item 1) by removing the three
hex bolts 1/4" x 1/2" (item 2) and the three lock
washers.
b) Remove the hair pin (item 3) and the pin (item 4). Raise
the lever (item 5) to remove the tension on the belts.
c) Remove the old belts (item 6) and install the new ones.
Make sure the belts are matched up and sold as a pair.
d) Reapply tension on the belts and secure the lever in
place with the pin and hair pin.
e) Reinstall the belt guard.
106443
UP
DOWN