Introduction
11
10.
Blank (Refer to
"Hiding the image" on page 26
for more information.)
Used to hide the screen image. Press Blank again to restore the image.
11.
Mode (Refer to
"Application Mode" on page 30
for more information.)
Depending upon which input signal is selected, there are several picture setup options
available.
Remote control effective range
Infra Red (IR) remote control sensors are located on the front and the back of the projector.
The remote control must be held at an angle within 30 degrees of the projector’s IR remote
control sensors to function correctly. The distance between the remote control and the
sensors should not exceed 6 meters (~ 20 feet).
Make sure that there are no obstacles between the remote control and the IR sensors on the
projector that might obstruct the infra-red beam.
Installing or replacing the remote control battery
1.
Pull out the battery holder.
2.
Insert the new battery in the holder.
Note the positive polarity should face
outward.
3.
Push the holder into the remote
control.
•
Avoid excessive heat and humidity.
There may be danger of an explosion if
the battery is incorrectly replaced.
•
Replace only with the same or equivalent
type recommended by the battery
manufacturer.
•
Dispose of the used battery according to the manufacturer’s instructions.
•
Never throw a battery into a fire.
•
If the battery is dead or if you will not be using the remote control for a long time, remove
the battery to prevent damage to the remote control from possible battery leakage.
~ 6 M
Содержание PB6240 - XGA DLP Projector
Страница 1: ...Welcome PB6240 Digital Projector Portable Series User s Manual...
Страница 6: ...Table of contents vi Memo...
Страница 53: ...Specifications 47 Dimensions Unit mm...
Страница 56: ...Regulation Statements 50 Memo...
