BendPak MDS-6EXT, Инструкция по установке и эксплуатации

Страница: 43 / 92

MDS-6 Mid-Rise Scissor Lifts
43
P/N 5900030 — Rev. D — April 2021
To connect the Hydraulic Hoses :
1. If the Platforms are not already engaged on their top
Safety Locks, raise them now, using a Shop Crane or
Forklift.
Refer to
Lift the Platforms off the Bases for
additional information.
2. If the front and top of the Console are in place, remove
them.
3. Find a good location for the Flow Divider on or near the
bottom of the Console. The Flow Divider need
not be
secured to the Console or the floor. See figure to the
right.
4. Attach an Elbow Hydraulic Fitting (5550103) to one of
the two Hydraulic Power
Out ports on the Power Unit.
Use PTFE Sealant on all fittings with NPT threads. See
figure below.
5. Locate the Medium Hydraulic Hose (18 inches, 458 mm).
6. Connect one end of the Medium Hydraulic Hose to the Elbow Hydraulic Fitting you just installed on
the Power Unit and the other end to the
In
connector on the Flow Divider. Finger tighten the
connections. No PTFE Thread Sealant is required for the JIC Flared Hydraulic Hose connections.
If you have trouble identifying the Power and Return Ports on the Power Unit refer to the
Connect
and Prepare the Power Unit
for a diagram showing the port locations.