Kaba Group Keyscan NETCOM6P, Руководство по установке

Страница: 1 / 20

NETCOM6P-Encrypted Installation Guide
This guide outlines how to install and program the NETCOM6P—serial to Ethernet
converter—for network communication. As the NETCOM6P can be configured to operate
with a CIM or directly from a PC109x or later control board, this guide is divided into the
following 2 separate installation sections:
 NETCOM6P/CIM Installation—page 2
 NETCOM6P/ACU Control Board Installation (PC109x or later)—page 11
Please refer to the appropriate installation instructions and diagrams. Installation
procedures are different for each type of configuration.
Important
Installing the NETCOM6P involves 2 wiring procedures: temporary serial programming
connections and permanent operation connections. This applies to both types of
installations. Please be sure to review the relevant diagrams for programming and
operating connections.
Before You Start
 Verify that you have all the parts as outlined below.
 Obtain a static IP address, Subnet Mask, and, if applicable, a Gateway from the
network administrator for each NETCOM6P. Space for recording addresses is provided
at the back.
 Ensure that you install the latest Keyscan NETCOM Program Tool utility, which is on
the enclosed CD, on a laptop or PC that can be serially connected to program the
NETCOM6P.
About the Reset Function
During the NETCOM6P programming procedures, you are prompted to reset the device,
which is a soft re-boot. This is equivalent to a power cycle.
Contents
NETCOM6P/CIM Installation 2
NETCOM6P/ACU Installation 12
Specifications 20
Parts List
NETCOM6P 1
Serial Data Cable 1
Utilities & Drivers CD 1