Keyscan Inc. A Member of the Kaba Group
18
NETCOM6P/Control Board Operational Connections
Figure 9 illustrates NETCOM6P operating connections and jumper settings when mounted
on a PC109x or higher control board. This configuration only supports a single control
board communication loop.
Note
If connecting a PC109x control board activate M1 for communication with the NETCOM6P
as follows:
J16 – pin F - ON / pin G – OFF
S2 – switch 7 – ON / switch 8 - OFF
Multiple Building Communication on a WAN
Keyscan requires a point-to-point private network where NETCOMs are used on a LAN/WAN
(TCP/IP) that integrates building to building communication.
Figure 9 - NETCOM2P/PC109x (or higher) Control Board Connections
- PC
- 10/100 Base-T Cable
- Control Board
- NETCOM2P or NETCOM6P
to network
Host PC with
Communication Manager
Parts List
to network
10 or 100
Base-T
Current Draw
ACU + NETCOMP = 270 mA
R
J
4
5
T
e
rm
in
a
l
J
a
c
k
N
E
T
C
O
M
P
R
E
S
E
T
Control Board
(PC 109x)
Cut view with
ACU protective
cover removed.
Common
AUX Inputs - E
CPB/CB MODULE
(COM4)
AUX Inputs - D
Common
IOCB (COM1)
NETCOMP plugs into M1 on
control board.
RX
TX
KI-00161E-04-13
J16
Pin F = ON
Pin G = OFF
Or
S2
DIP switch 7 = ON
DIP switch 8 = OFF
