Keyscan Inc. A Member of the Kaba Group
4
Installation Steps ...cont’d
8.
Select start > All Programs > and open the Keyscan NETCOM Program Tool from the
Keyscan menu.
9.
From the Keyscan NETCOM Utility screen, click on Program NETCOM Device.
10.
From the select NETCOM Device Type screen, click on the Program NETCOM6 Family
of Boards button.
11.
From the Program NETCOM6B, NETCOM6 & NETCOM6P Boards screen, enter the IP
address, the Subnet Mask, and, if applicable, the Gateway (optional).
12.
From Program via IP Address or Serial Port, select the port on the laptop or PC with
the serial connection to the CIM in order to program the device.
13.
Select the baud rate that corresponds to the J16 or S2 communication settings
depending on the version of PC109x control board.
14.
Leave Ethernet Connection Type on Automatic negotiation unless the IT administrator
gives a specific setting.
If the NETCOM device experiences network communication difficulties, you may
have to alter the Ethernet Connection Type from automatic negotiation. (The
Ethernet Connection Type is the network speed & duplex setting). Set the
NETCOM so it matches the network equipment setting. If the network equipment
was on an automatic setting, then reconfigure both the network equipment,
