MDS-6 Mid-Rise Scissor Lifts
65
P/N 5900030 — Rev. D — April 2021
6.
Walk completely around the Vehicle and make sure there are no obstructions or any other issues
that will interfere with the raising of the Lift and the Vehicle. Pay careful attention to overhead
clearances. If there are any obstructions, remove them before raising the Vehicle.
⚠
WARNING
Never
lift a Vehicle with the center of gravity shifted off the Lift Platforms.
7.
At the Console, press and hold the
Raise
button until the Rubber Pads come into contact with the
Vehicle’s lifting points. Release the
Raise
button, and walk around the Vehicle again to verify the
lifting points are securely engaged on the Rubber Pads. Verify the Vehicle is stable and balanced
on the Lift Pads.
⚠
DANGER
Do not raise the Lift further until you are certain the Vehicle on the Lift is both stable
and balanced. If the Vehicle is not stable and balanced, it could fall, which could
damage the Vehicle, damage the Lift, or injure or kill anyone under the Vehicle.
⚠
WARNING
Always allow a minimum of two-seconds delay between motor starts. Failure to
comply may cause switch and/or Motor burnout. This could cause serious damage
to the equipment and/or personal property.
8.
If the Vehicle is secure, press the
Raise
button. Watch the Vehicle and the Lift as they rise.
If the Lift becomes unstable or the Vehicle begins moving, release the
Raise
button immediately
and carefully lower the Lift back down to the ground.
9.
When the Platforms are slightly past the desired height, release the
Raise
button.
10.
Press the
Lower
button briefly to move the Lift down onto the most recently passed Safety Lock.
Always ensure all Safety Locks are engaged
before entering the work area.
Tip
If you move the Lift too far past a Safety Lock, it will not engage when you press
Lower
briefly. If this happens, move the Lift back up again, going a little less past
the Safety Lock, and then lower it back down onto the Safety Lock.
⚠
DANGER
Do
not
go under the Vehicle until you have confirmed that both the Lift Platforms
are resting on a Safety Lock at the same height.
Содержание MDS-6EXT
