BendPak MDS-6EXT, Инструкция по установке и эксплуатации

Страница: 34 / 92

MDS-6 Mid-Rise Scissor Lifts
34
P/N 5900030 — Rev. D — April 2021
Assemble and Anchor the Console
The Hydraulic Hoses, Air Line, and Return Line require the Console to be within 40 inches of the
cylinder end of the Lift on either the left or right side.
Tip If you want to set up the Console further than 40 inches from your Lift, you will need to
have Hydraulic Hoses fabricated that are long enough to reach the Lift from the
desired location. You may be able to obtain these Hoses from the local hydraulics
shop, once you know how long you need them to be. You will also need longer Air
and Return Lines.
For safety purposes, the Console operator must be able
to see the Lift during operation
.
The following procedure describes assembling and anchoring the Console into place. If you prefer, you
can defer anchoring the Console until you are sure of its permanent location.
Why would you defer anchoring the Console? Anchoring the Console is a relatively permanent
decision. Delaying the anchoring gives you a chance to evaluate how well you like your first choice for
the location of the Console. It is easier to change the Console location later if it is not anchored.
When you want to anchor the Console in place, return to this section and follow the instructions.
To assemble and anchor the Console
:
1. Select a site for the Console that permits operator to have a full, unobstructed view of the Lift.
The Console may be mounted on either the left or right side of the Lift, up to 40 inches away from
the Cylinder end in a direct line from the square opening in the Lift Base where the Hydraulic and
Air Lines will be
routed.
2. Using the Console
Base dimensions
provided here, sketch
with chalk, pencil or
tape the outline of the
console on the
concrete. Verify that
the chosen location
allows an
unobstructed view of
the Lift and will not
interfere with opening
the Vehicle doors, or
cause any other
interference.