BendPak MDS-6EXT, Инструкция по установке и эксплуатации

Страница: 33 / 92

MDS-6 Mid-Rise Scissor Lifts
33
P/N 5900030 — Rev. D — April 2021
4. Insert an Anchor Bolt with Washer into each hole, then tap it down into the hole.
5. Make sure the Washer and Nut are in place, then insert the Anchor Bolt into the hole.
The Expansion Sleeve of the Anchor Bolt may prevent the Anchor Bolt from passing through the
hole in the Base; this is normal. Use a Hammer or Mallet to get the Expansion Sleeve through the
Base and into the hole.
Even using a Hammer or Mallet, the Anchor Bolt should only go into the hole part of the way; this is
normal. If the Anchor Bolt goes all the way in with little or no resistance, the hole is too wide.
Once past the hole in the Base, the Anchor Bolt eventually stops going down into the hole as the
Expansion Sleeve contacts the sides of the hole; this is normal.
6. Hammer or Mallet the Wedge Anchor the rest of the way down into the hole.
Stop hammering when the Washer is snug against the Base.
7. Wrench each Nut clockwise
to the recommended installation torque, 85 – 95 ft-lbs., (115 – 129
N∙m) using a Torque Wrench.
Important : Do
not
use an impact wrench to torque the Anchor Bolts.
Wrenching the Nut forces the Wedge up, pushing out the Expansion Sleeve and pressing it tightly
against the Concrete.