BendPak MDS-6EXT, Инструкция по установке и эксплуатации

Страница: 28 / 92

MDS-6 Mid-Rise Scissor Lifts
28
P/N 5900030 — Rev. D — April 2021
4. Move the two Platforms into position where the Left and Right Chalk Lines intersect the Alignment
Chalk Line.
Tip
If you are installing the Lift over a pit, you can skip the Left and Right Chalk Lines
and just use the edges of the pit as guides. Do not overhang the pit.
5. Measure the distance between the two Platforms at points a and b ; the two Platforms need to be
the same distance apart at both points.
If
a and b are not the same, adjust the Platform locations; make sure they are the same distance
apart and parallel to each other (or the pit, if installing over a pit).
6. When the Platforms are in the correct locations, they can be anchored into place.
Lift the Platforms off the Bases
You must raise the Platforms off their Bases in order to anchor the Lift into position and connect the
Hydraulic Hose, Air Line, and Return Line.
Be sure to leave the Lift on a Safety Lock when
you raise it.
Important : BendPak recommends using the Eye Bolt that comes with the Lift to raise the
Platforms off the Bases.
⚠
WARNING
BendPak strongly recommends using at least three people to lift the Platforms
off their Bases: one person on each end to hold down the Base and one person to
operate the Forklift or Shop Crane to raise the Platform.
Use care when raising
the Platforms off their Bases; they are heavy and sometimes difficult
to hold
.
⚠
WARNING
You
must
wear OSHA-approved (publication 3151) Personal Protective Equipment
at all times when installing the Lift: leather gloves, steel-toed boots, eye protection,
back belts, and hearing protection are
mandatory .
To lift the Platforms off the Bases :
1. Retrieve the Lifting Eye Bolt from the Parts Box and install in the M10 threaded hole in the middle
of the Platform you want to raise.
2. Attach a rope, chain or Industrial Sling to the Eye Bolt and use a Forklift or Shop Crane to raise the
Platform off of its Base.
⚠
WARNING
Do not put any part of your body under the Platform while it is being lifted. Use a
wood 2 x 4 or other suitable device to hold the Base in position until the Platform is
secure on the top safety lock.
⚠
WARNING
The Lifting Frame Assemblies are heavy. Do not lift the Platforms without
assistance.
Tip
Once the Platform and Base are separated by more than half an inch (~13 mm), you
may use industrial slings (straps) around each end to continue raising the Platform off
the Base. You can continue using the Eye Bolt, if you prefer.