LR-10000 Low-Rise Scissor Lift
18
P/N 5900075 — Rev. A1 — April 2019
4.
Make sure the Washer and Nut are in place (you want approximately 1/4 inch to 1/3 inch — 6 to 8
mm — of thread visible above the nut), then insert the Anchor Bolt into the hole.
The Expansion Sleeve of the Anchor Bolt may prevent the Anchor Bolt from passing through the
hole in the Base; this is normal. Use a hammer or mallet to get the Expansion Sleeve through the
Base and down into the hole.
Even using a hammer or mallet, the Anchor Bolt should only go into the hole part of the way; this is
normal. If the Anchor Bolt goes all the way in with little or no resistance, the hole is too wide.
Once past the hole in the Base, the Anchor Bolt eventually stops going down into the hole as the
Expansion Sleeve contacts the sides of the hole; this is normal.
5.
Hammer or mallet the Anchor Bolt the rest of the way down into the hole.
Stop hammering when the Washer is snug against the Base.
6.
Wrench each Nut
clockwise
to the recommended installation torque, 110 – 150 foot pounds,
using a Torque Wrench.
Important
: Do
not
use an impact wrench to torque the Anchor Bolts.
Wrenching the Nut forces the wedge up, pushing out the Expansion Sleeve and pressing it tightly
against the Concrete.
Содержание LR-10000
