LR-10000 Low-Rise Scissor Lift
17
P/N 5900075 — Rev. A1 — April 2019
To anchor your LR-10000
:
1.
Make sure the Lift is in the correct location.
Once the Anchor Bolts are torqued into position, they are not easily removed. BendPak strongly
recommends making sure the Lift is in the correct location
before
anchoring it into place.
2.
Using the eight holes in the Base as guides, drill the holes for the Anchor Bolts.
Note
: If you prefer, you can mark the Anchor Bolt hole locations, move the unit out of the way,
drill the holes, and then move the unit back into position.
When drilling, go in straight; do not let the drill wobble.
Use a carbide bit (conforming to ANSI B212.15-1994).
The diameter of the drill bit
must
be the same as the diameter of the Anchor Bolt. So if you are
using a ¾ inch diameter Anchor Bolt, for example, use a ¾ inch diameter drill bit.
3.
Use a vacuum to thoroughly clean each hole.
If a vacuum is not available, use a wire brush, hand pump, or compressed air.
Do
not
ream the hole. Do
not
make the hole any wider than the drill bit made it.
Содержание LR-10000
