BendPak Clearfloor 10AP, Инструкция по установке и эксплуатации

Страница: 60 / 96

10AP Series Two-Post Lifts
60
P/N 5900265 — Rev. A6 — December 2022
To perform an Operational Test :
Make sure you have covered all the areas in Review Final Checklist before Operation
before proceeding further.
Follow the instructions in
Raising a Vehicle and Lowering a Vehicle to safely raise and lower
a Vehicle on the Lift.
⚠
DANGER
Follow the instructions carefully when it comes to contacting the manufacturer’s
recommended Lifting Points on the underside of the Vehicle. If you do not, the
Vehicle could become unstable and fall, which could damage the Vehicle, damage
the Lift, and injure or even kill anyone under the Vehicle.
Adjust the Lift Arms under the Vehicle so the Adapters are directly under the Lifting Points for the
Vehicle you are raising. If necessary, use the included Auxiliary Adapters for extra height.
Press the
Up
button to raise the Lift until just before the Adapters contact the Lifting Points.
Check the Arm Restraint Gears on all four Lift Arm Assemblies to make sure they are engaged. If
they are not engaged, move the Lift Arms back and forth until they engage.
Raise the Lift until the tires of the Vehicle are a few inches off the ground.
Verify all four Adapters are making solid contact with all Lifting Points.
If any of the Adapters are
not making solid contact with the Lifting Points, carefully lower the Lift
and start over again; the Adapters
must
make solid contact with all Lifting Points.
Raise the Vehicle approximately three feet off the ground, then release Up , then press and hold the
Safety Lock Release Handle and the Lowering Handle to lower the Lift back down.
NOTICE Residual air in the Hydraulic System can cause the Lift to shake, move erratically, or
squeak; this is normal when you first start using the Lift. It will soon stop doing this,
as the Hydraulic System is self-bleeding.
Wait for one minute.
⚠
WARNING The Power Unit is not a constant duty motor;
it cannot be run continuously
.
Repeat the process, this time raising the Lift, engaging it on a Safety Lock position, taking it off the
Safety Lock position, and then lowering it back down to the ground.
If the Lift is working without shaking, moving erratically, or squeaking, there is no need to repeat
the procedure. If the Lift is shaking, moving erratically, or squeaking, repeat the procedure one
more time. If you continue to have issues, refer to Troubleshooting for assistance.
When the Lift is on the ground and the Vehicle is on all four tires, move the four Lift Arms to their
full drive-through positions, then drive the Vehicle out.
With no Vehicle on the Lift Arms, press and hold the
Up button on the Power Unit.
Have another person push up the Safety Shutoff Bar until it triggers the Microswitch.
If the Lift Arms do not stop rising when the Microswitch is triggered, this means the Microswitch is
either not installed correctly or not wired correctly. Return to the sections in this manual where
installation and wiring of the Microswitch is described to identify and correct the issue.
⚠
CAUTION
Do not put the Lift into normal operation until you have confirmed that triggering the
Microswitch stops the Lift Arms from rising.