BendPak Clearfloor 10AP, Инструкция по установке и эксплуатации

Страница: 33 / 96

10AP Series Two-Post Lifts
33
P/N 5900265 — Rev. A6 — December 2022
Anchoring the Posts
⚠
DANGER Pay
special
attention when installing the Posts. If done incorrectly, the Lift could
fall over, potentially causing damage to the Vehicle, the Lift, and injuring bystanders.
Concrete specifications are:
• Depth : 4.25 inches / 108 mm thick,
minimum
• PSI : 3,000 PSI, minimum
• Cured : 28 days, minimum
Anchor Bolt specifications are:
•
Length : 6.3 inches / 160 mm
• Diameter : .75 inch / 19 mm
•
Anchor torque
: 85 – 95 pound feet
(never less than 80 or more than 110)
• Effective embedment : 3.25 inches / 82.5
mm or more
The Concrete floor where you want to install your Lift must meet the following requirements:
• The floor must be a flat, concrete floor. It must be level;
do not install the Lift on a surface
with more than three degrees of slope
.
• Do not install the Lift on cracked or defective Concrete.
• Check the floor for the possibility of it being a post-tension slab. In this case, contact the building
architect before drilling. Using ground penetrating radar may help you find the tensioned cable.
⚠
WARNING Cutting through a tensioned cable can result in injury or death. Do not drill into a
post-tension slab unless the building architect confirms you are
not going to hit a
tensioned cable, or you have located it using ground penetrating radar.
If colored
sheath comes up during drilling, stop drilling immediately .
⚠
WARNING Your concrete and Anchor Bolts
must
meet these specifications. Only install your
Lift on a Concrete surface. If you install a Lift on asphalt or any other surface, or
your Concrete or Anchor Bolts do not meet these specifications, it could lead to
product damage, Vehicle damage, personal injury, or even loss of life.
BendPak Lifts are supplied with installation instructions and concrete fasteners meeting the criteria as
prescribed by the latest version of the American National Standard “Automotive Lifts – Safety
Requirements for Construction, Testing, and Validation”.
⚠
WARNING Use
only
the ALI-certified Anchor Bolts that came with your 10AP Series Two-Post
Lift. If you use components from a different source, you void your warranty and
compromise the safety of everyone who installs or uses the Lift.
Lift buyers are responsible for conforming to all regional, structural, and seismic anchoring
requirements specified by any other agencies and/or codes, such as the Uniform Building Code and/or
International Building Code.
NOTICE Consider not torquing the Anchor Bolts into position yet. Installing the Overhead
Assembly and doing final leveling may be easier if there is some play in the Posts.