Problem Solving
Answering System does not work, check the following:
1.
BASE UNIT
is plugged into a power source.
Answering System does not answer calls, check the following:
1. ANSWER ON/OFF LED indicator is lit.
Answers calls only after 10 rings, check the following:
1. ANSWER ON/OFF LED indicator is lit.
2. Message Memory is not full.
Does not respond to remote commands, ensure the following:
1. Correct Remote Access Code is entered.
2. A TONE telephone is being used.
Message are incomplete, ensure the following:
1. Message Memory is not full.
2. Caller may be hesitating and pausing for more than 7 seconds.
Answer calls but not record messages, check the following:
1. ANNC/ICM switch is set to ICM.
2. Memory is not full.
3. Extension telephone was not picked up.
Answering System announces “Time is off” at the end of each message, check the
following:
1. Have you set the Day/Time?
2. Was there a power interruption?
RE-initiate your cordless telephone:
1. You can re-initiate your unit once the unit is not working properly. Unplug and plug the AC
adapter, then press and hold down the
button for more than 3 seconds, then release the
button until a beep sounds.
NOTE
: If none of telephones in the house are working, disconnect one set at a time to verify that
none of the phones are causing the problem. If you still have a problem after doing this, and
your telephone still does not work, please contact your local phone company.
Technical Information
Technical information
This cordless telephone uses radio frequencies to allow mobility. There are certain difficulties, in
using radio frequencies with a cordless telephone. While these are normal, the following could affect
the operation of your system.
Noise
Electrical pulse noise is present in most homes at one time of another. This noise is most intense
during electrical storms. Certain kinds of electrical equipment such as light dimmers, fluorescent
bulbs, motors, and fans also generate noise pulses. Because radio frequencies are susceptible to
these noise pulses, you may occasionally hear them in your HANDSET. Generally they are a minor
annoyance and should not be interpreted as a defect in your system.
Range
Because radio frequency is used, the location of the BASE UNIT can affect the operating range. Try
several locations in your home or office and pick the one that gives you the clearest signal to the
HANDSET.
Interference
Electronic circuits activate a relay to connect the cordless telephone to your telephone line. These
electronic circuits operate in the radio frequency spectrum. While several protection circuits are used
to prevent unwanted signals, there may be periods when these unwanted signals enter the BASE
UNIT, You may hear clicks or hear the relay activate while you are not using the HANDSET. If the
interference occurs frequently, it can be minimized or eliminated by relocating the BASE UNIT. You
can check for interference before selecting the final BASE UNIT location by plugging in the
telephone.
NOTICE:
This cordless telephone uses radio communication between the
HANDSET
and the
BASE UNIT
and
may not ensure privacy of communication. Other devices, including another cordless telephone, may
interfere with the operation of this cordless telephone or cause noise during operation. Units not
containing coded access may be accessed by other radio communication systems, Cordless
telephones must not cause interference to any licensed radio service.
IMPORTANT
When you hear interference, press the
button to change the operating
channel.
scan
delete
stop
