BELGACOM Belgafax 170ts, Руководство пользователя

Страница: 34 / 40

34
H
in
ts & T
ip
s
Problems when faxing or printing
Faxes are of poor quality.
Change the resolution setting to
F
or
f
.
Check the document or set a higher contrast with
function 47 (see chapter
Fax & Copy
/ Con-
trast).
Test the fax machine by making a copy. If your
copy is faultless the correspondent’s fax machine
might be defective.
Call service if necessary.
Your fax or your recipient’s fax machine produces
black lines when printing. Clean the scanner with a cloth (see Care).
Test the fax machine by making a copy. If your
copy is faultless the correspondent’s fax machine
might be defective.
Call service if necessary.
Copy is blank. Load the document with the printed side up.
Call service if necessary.
Problems with the connection
Your fax machine rings once, then there is a mo-
ment of silence and another ring signal after that. This is entirely normal. After the fi rst ring signal
the fax machine takes over the call. When the fax
machine has recognised that the incoming call is
a telephone correspondence, the fax machine will
continue to ring.
NO CONNECTION
or
REDIAL FAILED
Try later or draw your fax partner’s attention to a
possible installation fault.
NO LOOP CURRENT
Check the installation of your fax machine.
When you lift the receiver of your fax machine
you do not hear the dial tone. Connect your telephone cable to the socket on
the bottom of your fax machine identi
fi ed with
LINE
.
BUSY
or
fax transmissions are constantly interrupted.
Try to send the fax manually: Press l and dial
the fax number. If the recipient is using an auto-
matic answering device, wait until you hear a tone
after the pre-recorded message. Press
START/
COPY
.
You cannot receive any faxes. Set the number of ringing signals for the answe-
ring machine or the total number of ringing si-
gnals with function 31 or 32 to lower than
fi ve.
On lifting the handset you hear a tone or silence. You are receiving a fax. At the fax machine: Press
START/COPY
. At an additional telephone:
press * and 5 . Replace the handset.
EXTERNAL PHONE
The red lamp
v
fl ashes.
This is not a fault. You are now using an additional
telephone.