Belden Hirschmann RPS90/48V HV, Руководство пользователя

Страница: 50 / 66

50
Installation RS20/22/30/32/40
Release 03 06/2013
100 MBit/s F/O ports enable the connection of terminal devices or
independent network segments in compliance with the IEEE 802.3
100BASE-FX standard.
These ports support:
 Full or half duplex mode
Default setting: Full duplex
Note: Make sure that the LH ports are only connected with LH ports, SM
ports are only connected with SM ports, and MM ports only with MM ports.

1 Gbit/s F/O connection
These ports are SFP slots.
1000 Mbit/s F/O ports enable the connection of terminal devices or
independent network segments according to the IEEE 802.3 1000BASE-
SX/1000BASE-LX standard.
These ports support:
 Autonegotiation
Note: Make sure that the LH ports are only connected with LH ports, SX
ports are only connected with SX ports, and LX ports only with LX ports.
Note: In device variants RS30-...02OOZZ... and RS32-...02OOZZ... (four
uplink ports with SFP slot), Gigabit-ETHERNET-SFP transceivers or
Fast-ETHERNET-SFP transceivers can be mounted at the two top ports,
and Fast-ETHERNET-SFP transceivers can be mounted at the two
bottom ports
“Accessories” on page 63 .
In device variants RS40-..., Gigabit-ETHERNET-SFP transceivers or
Fast-ETHERNET-SFP transceivers can be mounted at the combo ports
“Accessories” on page 63 .
2.2 Display elements
After the operating voltage is set up, the software starts and initializes itself.
Afterwards, the device performs a self-test. During this process, various
LEDs light up. The process takes around 60 seconds.

Device state
These LEDs provide information about conditions which affect the
operation of the whole device.