GUIDE TO INSTALLATION AND OPERATION
MDX-3901 |
27
5.5.7 Config tab
This tab is available in embedder mode only.
It contains an Audio Insert pulldown for each of the four audio
groups (1 to 4) embedded in the output SDI.
Use the pulldown to set the following options:
Pass:
the initial content of the group included in the SDI
input is passed to the SDI output untouched.
Blank:
the group will be empty in the SDI output.
Embedding Out CHX-X:
embed these audio channels
as the group source in the SDI output.
5.6 Audio Alarms panel
5.6.1 Overload tab
This tab sets the true peak overload alarm threshold and
hysteresis for the 16 audio channels.
Select a
TP
Overload CHX
row to configure it in the
Output
section below.
Apply To All:
set to apply the settings made in the
Output
section to the
Output
settings of all
TP Overload CHX
channels at the same time.
Enable
: set to enable overload alarms for the selected
channel.
Threshold (dBFS)
: sets the overload threshold level for the
selected channel.
Set Duration (sec)
: sets the amount of time the level must
exceed the threshold before the overload alarm is triggered.
Clear Duration (sec)
: sets the amount of time the level must
be below the threshold before the overload alarm is cleared.
LED Color
: sets the status color of the front panel led for the
overload alarm when activated.
Figure 5.11 Audio Processing, Config tab
Figure 5.12 Audio Alarms, Overload tab
