Belden 934 815-001, Техническое руководство

Страница: 54 / 72

Diagnostics processing
50
8.1 Diagnostic settings on the
BusHead
Technical manual LioN-Link BusHead EtherNet/IP™
Release 1.1 04/2016
8.1 Diagnostic settings on the BusHead
On the web server's "Config" Page, you can configure the following
diagnostics settings for the default settings shown for the BusHead in the
"Edit" column.
8.1.1 Diagnostic Acknowledge

Diagnostic Acknowledge Disabled
Diagnoses are only shown in the cyclic BusHead status byte 0 (see
chapter
“Cyclic diagnostic data” on page 51 ) and in the diagnostic blocks
if they are active. The BusHead control byte 0 is not used in this mode.

Diagnostic Acknowledge Enabled
Diagnoses are transferred with the cyclic data until the diagnoses are
acknowledged by the control program using BusHead control byte 0 (see
chapter
“Cyclic diagnostic data” on page 51 ) or on the integrated web
server. This means that short diagnostic results remain available until
acknowledged.
8.1.2 Diagnostic Block Mode
To reduce the data load in the cyclic data, you can use a parameter to cut
down to only two active diagnostic blocks.