Belden 934 815-001, Техническое руководство

Страница: 41 / 72

The integrated web server
Technical manual LioN-Link BusHead EtherNet/IP™
Release 1.1 04/2016
6.4 The Status page
37
On this page the embedded web server shows you the "Diagnostic Status"
of the LioN Link system. The left table lists the existing module configuration.
Modules that report diagnostics are shown in red in the "Dia" column (with
existing diagnostic message), yellow (without existing diagnostic message)
or gray (diagnostics inactive).

Configuration errors are shown in the "Config" column. An incorrect module
type is shown as "Wrong", a missing module as "Missing" and swapped
modules are declared as "Interchanged".
The right hand table shows the "Diagnostic Messages" in cleartext. If you
have write privileges (Admin/Write), you can click the button in the "Ack"
column (Acknowledge) to acknowledge the diagnostics (see section
“Diagnostics processing” on page 49 ). However, this is only possible if
Acknowledge Mode is enabled in the BusHead.
Clicking the "Reload Diag" button refreshes the diagnostic display. Since the
display states are not updated automatically, you can use "Auto update
interval" to configure a time for refreshing the website.

If this is not desired, this function can be disabled using the "0" value. In case
of a configuration change, the BusHead clears the diagnostic memory
automatically if Acknowledge Mode is disabled. Is the BusHead is involved
in cyclic communication, "Scan Bus" can be used to parse the LioN Link bus
again.


The Connection state "Communicating" indicates cyclic communication with
the controller. If the "Idle" state is shown, there is no exchange of process
data with the controller.