BELARUS-1021/1021.3
Operating manual
58
5.2 Checking and adjusting toe-in
Attention
— Check and adjust toe-in every 250 service hours of the tractor and after each
change of the front wheel track. Before checking the toe-in, always check and, if necessary, adjust
the play in the steering rod joints.
1, 3 — nut, 2 — steering rod adjusting tube.
Checking and adjusting toe-in
To check and, if necessary, adjust the toe-in of the BELARUS -1021/1021.3 tractors,
proceed as follows:
- set the required tire pressure in accordance with the instructions in Table Standards of
loads on tires to choose mode at various internal pressures in 6.10 of
6 UNITIZING
;
- on a flat site, drive the tractor forward at least 3 meters and stop. Engage the parking
brake.
- measure the distance B between two opposite points on the rim flange behind the front
axle at the height of the wheel axle.
- move the tractor forward so that the front wheels turn by about 180°, then measure the
distance A in front of the front axle between the same points as in the measurement of the size B.
The toe-in is correct if the dimension A is 0 to 8 mm less than the dimension B. If the toe-in does
not meet these values, procede as follows:
1. Unscrew the nuts (1) and (2) of the steering rod adjusting tube (2).
2. Rotating the tube, set the desired toe-in;
3. Tighten the nuts (1) and (3).
Содержание 1021
Страница 1: ...BELARUS 1021 1021 3 1021 0000010 OM OPERATING MANUAL Minsk Tractor Works 2010 ...
Страница 16: ...BELARUS 1021 1021 3 Operating manual 15 The transmission number Front driving axle number Cab serial number ...
Страница 107: ...BELARUS 1021 1021 3 Operating manual 106 Fig 6 9 2 Determining maximum allowable torque Power kW hp Speed rpm Torque Nm ...