BELARUS-1021/1021.3
Operating manual
10
1. SAFETY PRECAUTIONS
1.1 General instructions
1.1.1 Strict observance of safety precautions and strict compliance with tractor operation
and maintenance rules ensure its fully safe operation.
1.1.2 Carefully read the opeator’s instruction before you operate the tractor. Insufficient
knowledge on tractor control and operation may result in accidents.
1.1.3 Only specially trained and skilled operators are allowed to operate the tractor.
1.1.4 If the tractor is equipped with a safety belt, use it when working. If the tractor has no
safety belts, contact your dealer.
1.1.5 Do not take a passenger into the cab if no extra seat and handrail is installed. There is
no other safe place for a passenger in the cab!
1.1.6 Keep clean all warning plates. If the plates are damaged or lost, replace them with
new ones.
1.1.7 Before starting the work, carefully inspect the tractor, trailed machine, implement and
hitch. Get started only when you make sure they are in good condition. Trailed agricultural
machines and transport trailers must have rigid hitches excluding their swinging and hitting the
tractor during transportation.
1.2Safety precautions for tractor operation
1.2.1 Before starting the engine, engage the park brake and:
- with single lever control — shift the gear-change and range-change lever to the position
of the I-st or II-nd range;
- with two-lever control — shift the range-change lever to the position of the I-st or II-nd
range and shift the gear-change lever to the Neutral position;
1.2.2 Before you begin the movement, horn to warn other people being around and working
on trailed machines.
1.2.3 Do not abandon the tractor during movement.
1.2.4 Before leaving the cab, turn off the PTO, stop the diesel engine, engage the parking
brake and remove the starter and instrument key.
1.2.5 Do not work on the tractor indoors if adequate ventilation is not available, as exhaust
gases can cause death.
1.2.6 To avoid damage to power gear of the PTO drive, do not use the synchronous drive at
speeds above 8 km/h.
1.2.7 If the engine or the steering fail during work, immediately, stop the tractor.
Remember that when the engine is stopped, you need a much greater force on the steering wheel to
control the tractor.
1.2.8 Do not work under lifted implements. For long stops, do not leave a mounted
implement in the raised position.
1.2.2.9 If the front of the tractor takes off the grond when hinging heavy machines or
equipment on the hinging mechanism, install the front counterweights.
1.2.10 When working with a front loader, fill the rear tires with a liquid ballast.
1.2.11 Before raising or lowering a mounted implement, as well as before turning the
tractor, make sure that there is no danger to hurt anyone or get caught on an obstacle.
1.2.12 The driveshaft transmitting rotation from the tractor PTO to tools of the unit must be
enclosed.
Содержание 1021
Страница 1: ...BELARUS 1021 1021 3 1021 0000010 OM OPERATING MANUAL Minsk Tractor Works 2010 ...
Страница 16: ...BELARUS 1021 1021 3 Operating manual 15 The transmission number Front driving axle number Cab serial number ...
Страница 107: ...BELARUS 1021 1021 3 Operating manual 106 Fig 6 9 2 Determining maximum allowable torque Power kW hp Speed rpm Torque Nm ...
