BELARUS-1021/1021.3
Operating manual
162
Operation 30. Change engine oil
Before changing oil, warm up the engine to the normal operating temperature (70°C min.),
install the tractor on an even surface, kill the engine and brake tractor with the parking brake.
To change oil in the engine crankcase, proceed as follows:
- remove the cover (2) (Fig. 8.4.24) of the oil filler neck (1) and unscrew the drain plug (4);
- drain the oil into a container for storing waste oils;
- reinstall the drain plug (4) and through the oil filler neck (1) fill fresh clean motor oil
(winter grade according to Table 8.4 during winter and summer grade during summer) up to the
upper mark on the oil gage stick (3);
- install the filler neck cover (2) to place;
- start the engine and let it run for one to two minutes;
- in ten minutes after stopping the engine, check the oil level using the oil gage stick (3);
- if necessary, add oil to the engine crankcase.
1 — oil filler neck; 2 — cover; 3 — oil level gage; 4 — drain plug.
Fig. 8.4.24 – Change engine oil
Caution:
Be careful to avoid contact with hot oil!
Operation 31. Replace engine oil filter
Replace the filter element according to Fig. 8.4.25 simultaneously with changing oil in the
engine crankcase in the following order:
- screw out the filter FM 009-1012005 from the connecting piece using a special wrench or
other means available;
- screw a new filter FM 009-1012005 on the connecting piece.
*When installing the filter on the casing, lubricate the gasket 3 with motor oil.
After the shim touches the support surface of the filter housing 1, screw the filter by
additional 3/4 turn. Install the filter on the casing only by force of the hands.
Further on, to order oil filters FM 009-1012005 use the contact address: Avtoagregat OJSC,
2a Industrialnaya St., Livny 303858, Orel region, Russia.
Instead of filters FM 009-1012005, you can install sealed filter cartridges such asAS Lelko
H149 (France),Purolator L37198 (Italy) and from other vendors, which have an anti-drain valve
and a bypass valve with main dimensions as follows:
- diameter — 95 ... 105 mm;
- height — 140 ... 160 mm;
- thread —."-16UNF.
Содержание 1021
Страница 1: ...BELARUS 1021 1021 3 1021 0000010 OM OPERATING MANUAL Minsk Tractor Works 2010 ...
Страница 16: ...BELARUS 1021 1021 3 Operating manual 15 The transmission number Front driving axle number Cab serial number ...
Страница 107: ...BELARUS 1021 1021 3 Operating manual 106 Fig 6 9 2 Determining maximum allowable torque Power kW hp Speed rpm Torque Nm ...
