BELARUS-1021/1021.3
Operating manual
57
Table, continued
Tractor rack K, mm
(360/70R24 tire)
Variants of disk and rim
installation
Disk offset
X, mm
Short beam Long beam
Method of installation
+ 56
1,585
1,705
The disk is mated with the
outer surface of the support.
+ 6
1,685
1,805
The disk is mated with the
inner surface of the support.
102
1,900
2,020
The rim is rotated by 180
degrees. The disk is mated
with the inner surface of the
support.
Swapping the disk and
the rim
152
2,000
2.120
The rim is rotated by 180
degrees. The disk is mated
with the outer surface of the
support.
To adjust the track, perform the following operations:
- brake the tractor using the parking brake. Put stops before and after the rear wheels;
- jack up the front of the tractor (or the front wheels in turn), providing a clearance between
the wheels and the ground;
- remove the front wheels;
- unscrew the nuts fastening the wheel disk to the reducer flange (to obtain a track by
turning the wheel from side to side);
- unscrew the nuts fastening the wheel rim to the disk;
- depending on the desired track, set the corresponding relative position of the rim and disk as
shown on the chart in the table above. At that, make sure that the direction of rotation of the wheels
coincide with the direction of the arrow on the tire sidewall.
- when swapping the wheels, tighten the nuts fastening the disks to the flanges to a torque of
200 to 250 N•m, the nuts fastening the disks to the rim carriers to a torque of 180 to 240 N•m
Содержание 1021
Страница 1: ...BELARUS 1021 1021 3 1021 0000010 OM OPERATING MANUAL Minsk Tractor Works 2010 ...
Страница 16: ...BELARUS 1021 1021 3 Operating manual 15 The transmission number Front driving axle number Cab serial number ...
Страница 107: ...BELARUS 1021 1021 3 Operating manual 106 Fig 6 9 2 Determining maximum allowable torque Power kW hp Speed rpm Torque Nm ...