8
EN
Connecting water supply
C
The water supply pressure required to
run the product is between 1 to 10 bars
(0.1 – 1 MPa). It is necessary to have
10 – 80 liters of water flowing from the
fully open tap in one minute to have your
machine run smoothly. Attach a pressure
reducing valve if water pressure is higher.
C
If you are going to use the double water-
inlet product as a single (cold) water-
inlet unit, you must install the supplied
stopper to the hot water valve before
operating the product. (Applies for the
products supplied with a blind stopper
group.)
C
If you want to use both water inlets of
the product, connect the hot water hose
after removing the stopper and gasket
group from the hot water valve. (Applies
for the products supplied with a blind
stopper group.)
A
Models with a single water inlet should
not be connected to the hot water
tap. In such a case the laundry will get
damaged or the product will switch to
protection mode and will not operate.
A
Do not use old or used water inlet hoses
on the new product. It may cause stains
on your laundry.
1. Connect the special hoses supplied with
the product to the water inlets on the
product. Red hose (left) (max. 90 ºC) is
for hot water inlet, blue hose (right) (max.
25 ºC) is for cold water inlet.
A
Ensure that the cold and hot water
connections are made correctly when
installing the product. Otherwise, your
laundry will come out hot at the end of
the washing process and wear out.
2. Tighten all hose nuts by hand. Never use
a wrench when tightening the nuts.
3. Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any
leaks occur, turn off the tap and remove
the nut. Retighten the nut carefully after
checking the seal. To prevent water
leakages and damages caused by them,
keep the taps closed when the machine
is not in use.
Connecting to the drain
• The end of the drain hose must be
directly connected to the wastewater
drain or to the washbasin.
A
Your house will be flooded if the
hose comes out of its housing during
water discharge. Moreover, there is
risk of scalding due to high washing
temperatures! To prevent such situations
and to ensure smooth water intake and
discharge of the machine, fix the end
of the discharge hose tightly so that it
cannot come out.
• The hose should be attached to a height
of at least 40 cm, and 100 cm at most.
• In case the hose is elevated after
laying it on the floor level or close to
the ground (less than 40 cm above the
ground), water discharge becomes more
difficult and the laundry may come out
Содержание WMB 710311 D
