Beka Hospitec AVERO Phoenix, Руководство по эксплуатации

Страница: 21 / 35

Troubleshooting/After-sales service
Operating manual AVERO Phoenix V2.1 E Page 21 of 35
12. Troubleshooting/After-sales service
12.1 Troubleshooting help
Problems with the bath tub Remedy
The height adjustment of the lifting
bath tub is not working.
a) Check if the mains voltage is present.
b) Check if the control unit is damaged
c) Check if the connecting cable is damaged
The lifting bath tub remains in the top
end position.
Check if the mains voltage is present.
The hoisting motor does not run Check if the mains voltage is present.
The drive is switched off during the
lifting procedure.
The maximum load is exceeded ( max. patient weight ).
Mains LED and temperature
indications do not lit. Check if the fuse and the fault-current circuit breaker are
activated.
Mains voltage fails.
a) Check fuse.
b) Check the cables for damages.
No water.
a) Check the shut-off valves of the cold and hot water.
b) Check the filter situated in the water inlet.
The automatic filling is not working.
Disconnect the bath tub from the power supply. Perform
restart. If no result is obtained, contact the service/after-
sales service.
Only hot or cold water flows out of
the faucet.
a) Check the water supply. (local).
b) Check if the hot and cold-water connection are
reversed (locally, tub).
c) Check the filter as well as the inlet and outlet faucet for
clogging.
Too low a water flow rate.
a) Check the water supply. (local).
b) Check the filter as well as the inlet and outlet faucet for
clogging.
c) Check that the flow rate is sufficient for the supply
conditions.
d) Check if the connecting hoses are bent.