10
To the left of the display four
SOFTKEYS
, labelled
A, B, C
and
D
respectively, are to be found arranged
vertically. Their functions can be defined by the user software and displayed to the immediate right of
each key by the appropriate PICTOGRAM in the display. Each pictogram and its associated functions
will be comprehensively explained in chapter 2. You will find function diagrams for both EQ and RTA mode
as well as a list of all pictograms used next to the back cover.
8
The
CURSOR KEYS
.
To the right of the display the
CURSOR KEYS
are to be found. These are used:
1.) to select individual filter frequencies, and the master fader in EQUALIZER mode (horizontal)
2.) to adjust the value of each selected frequency (vertical)
3.) to position the measurement cursor in ANALYZER mode (horizontal)
4.) in both operating modes, to choose the program position (vertical)
5.) to select a field in the SETUP menu (horizontal and vertical)
+
In each case pressing on the opposite key while holding the key being used will accelerate
the operation being carried out.
Fig. 1.2: The back panel layout of the ULTRA-CURVE PRO
9
This is the
MAINS CONNECTOR / FUSE HOLDER / VOLTAGE SELECTOR.
Before you connect the
unit, please make sure that the displayed voltage corresponds to your Mains supply. Please note that
the AC voltage selection is defined by the position of the Fuse Holder. If you intend to change the
operating voltage, remove the Fuse Holder and twist it by 180 degrees before you reinsert it. Matching
the two markers monitors the selected voltage. Please note that, depending on the mains voltage
supplied to the unit, the correct fuse type and rate must be installed (see chapter 6.4 Technical Speci-
fications). Please use the enclosed mains cable to connect the unit to the mains power supply.
+
Please note that not all appliances can be used with different mains voltage ratings. Please
check the description on the back of the unit and the box.
10
The
MAINS SWITCH
is to be found above the mains socket. The switch is situated on the backpanel to
make the ULTRA-CURVE tamper proof with unattended use. The unit will bypass on power failure but
cannot be bypassed when a password is set.
11
Please take the time to make a note of the
SERIAL NUMBER
in the space provided on the enclosed
Warranty Registration Card. Put the instruction manual in a safe place and return the completed
Warranty Registration Card to us within 8 days of purchase, making sure that the dealer stamp
has been acquired.
12
AES/EBU IN
and
AES/EBU OUT.
These are the ULTRA-CURVE PRO's Digital Input and Output (op-
tional). The analog output signal is also present at the (analog) outputs when the digital out is used.
Both signals can be used in parallel.
13
These are the ULTRA-CURVE PRO's MIDI connectors (
MIDI OUT / THROUGH / IN
). Via these connec-
tors total remote control is possible.
14
ANALOG OUTPUTS
. These are the ULTRA-CURVE PRO's analog outputs. When the AES/EBU option
is installed the analog output will still be present at these outputs, so that both analog and digital out can
be used in parallel.
15
These are the ULTRA-CURVE PRO's
ANALOG INPUTS.
16
This is the
MIC INPUT
socket for the Reference Microphone.
1. INTRODUCTION
All manuals and user guides at all-guides.com
Содержание ULTRA-CURVE PRO DSP8024
Страница 49: ...49 E Fig 6 7 RTA window 6 APPENDIX All manuals and user guides at all guides com...
Страница 54: ...All manuals and user guides at all guides com...
Страница 55: ...All manuals and user guides at all guides com...
Страница 56: ...All manuals and user guides at all guides com a l l g u i d e s c o m...
