Beech Ovens
Page 132
28/07/2011 (C)
RND-REC-RGO Manual (R1)
Confidential and Proprietary
14.
Fault/Reset light comes on.
14.1
Gas supply problems. (For LPG, is tank near empty)
14.2
Ventilation problem, flame being drawn under the oven floor.
14.3
Tri-electrode dirty, contaminated, loose etc.
14.4
Leads to Tri-electrode faulty/fallen off.
14.5
Faulty Flame pack.
14.6
Faulty Gas Combination valve.
14.6
Air in gas lines. (refer to Connection procedures)
14.1.1
Check gas supply
(Contact service technician).
14.2.1
Refer to
System Balancing
or
www.beechovens.com
14.3.1
Refer to
Tri-electrode and Burner Maintenance.
14.4.1
Refer to
Connection Procedures.
14.5.1
Replace Flame pack.
14.6.1
Replace Gas Combination valve.
14.7.1
Refer to
Connection Procedures.
15.
Gas burner not turning off.
15.1
Thermocouple faulty / fallen out.
15.2
Faulty Digital Temperature controller
15.3
Check „SV‟ setting on Digital Temperature Controller.
15.4
Faulty Flame pack.
15.1.1
Refer to
Thermocouple
. Replace if faulty.
15.2.1
Refer to
Digital Temperature Controller.
15.3.1
Refer to
Digital Temperature Controller.
15.4.1
Replace Flame pack.
16.
No lights on Gas Control cabinet
(Digital Temp Controller/ Burner ON).
16.1
Power supply problems.
16.2
Circuit breaker inside cabinet tripped.
16.3
Bulbs faulty - blown
16.1.1
Check power supply
(Contact electrician).
16.2.1
Check power supply. Refer to
Gas Systems Overview.
16.3.1
Replace bulbs
17.
Flame leaking out from blow back
chute.
17.1
Incorrect System Balancing
17.2
. Ventilation problem, flame being drawn under the oven floor.
17.1.1
Refer to
System Balancing.
17.2.1
Refer to
Oven Ventilation.
18.
Excessive Gas consumption.
18.1
Incorrect System Damper calibration. Oven loosing heat.
18.2
Incorrect door position.
18.3
Incorrect flame calibration.
18.4
Incorrect gas pressure adjustment.
18.5
Leakage in supply line.
18.6
. Ventilation problem, flame being drawn under the oven floor.
18.7
Incorrect jet /orifice
18.1.1
Refer to
System Damper Calibration.
18.2.1
Refer to
Plug Door Placement.
18.3.1
Refer to
Flame Calibration.
18.4.1
Refer to
Flame Calibration.
18.5.1
Turn off main gas supply at Manual Gas Isolation Valve
in Gas Control Cabinet. Contact service technician.
18.6.1
Refer to
System Balancing
or
www.beechovens.com
18.7.1
Contact service technician
19.
Cracked upper refractory.
19.1
Insufficient Preheating of the oven.
19.1.1
Refer to
Preheating with Gas / Wood.
20.
Burner flame popping loud on
startup
20.1
Tri-electrode misaligned to flame
20.2
Build up of
charcoal or debris on burner
20.1.1
Refer to
Tri-electrode and Burner Maintenance.
20.2.1
Inspect and clean burner
