Beckman Coulter Optima LE-80K, Инструкция по эксплуатации

Страница: 21 / 52

1-3
Description
Actual (Current) Values
When the power is on, the displays show actual operating conditions
at all times except when the instrument is in editing mode or when
has been pressed (see below).
Set Values
Set values are the run conditions entered by the user. When you press
a parameter key, the associated display blinks to indicate that a value
can be entered or modified. This is referred to as the “editing” mode.
The display continues to blink until you press another parameter key
or
. If you press another parameter key, the associated
display begins to blink and the set values continue to be displayed.
If you press
, the instrument displays the set values for
5 seconds, then exits the editing mode and returns to showing actual
conditions. Set values remain in memory until new values are entered.
Whenever you press , the instrument displays the set
values for 5 seconds, then returns to showing actual conditions.
RUN STATUS INDICATORS
Run indicators are provided in the form of green and red LEDs to
indicate the status of the instrument. Figure 1-1 shows the location of
the LEDs on the control panel and Table 1-1 describes the meaning of
each. (Unless otherwise noted, the LEDs appear above their respec-
tive keys.)
DIAGNOSTIC MESSAGES
Diagnostic messages appear as red LEDs under the SPEED display
(see Figure 1-1) to alert you to conditions that may need attention.
The indicators are not visible unless an abnormal condition occurs.
The meanings of the diagnostic messages, as well as appropriate
actions to take, are discussed in Section 4,
TROUBLESHOOTING AND
MAINTENANCE
.
ENTER/RECALL
ENTER/RECALL
ENTER/RECALL
ENTER/RECALL