5
Part No. 6-847703-00 Rev. C00
Installation
Wall Mounting Manifold Control
Figure 1
1. Remove manifold control panel from shipping
carton and place face down on foam
packaging insert.
2. Mounting bracket is shipped attached to back
of manifold control panel. Remove lower 3/8"
mounting nut as shown in Figure 1. Pull
bottom of bracket away from manifold control
panel and slide bracket off two upper control
panel mounting bolts.
3. Mark wall 79-3/4" from finished floor in
location where manifold will be mounted.
Convert mark to level horizontal line
approximately 8" long.
3/8 Nut
Mounting
Bracket
Manifold
Control Panel
NOTE:
A bracket height of 79 3/4” allows for adequate
clearance beneath manifold when utilizing
standard “H” size cylinders (55” tall overall).
Bracket mounting height should be increased
proportionally if taller cylinders are to be used.
