13
Part No. 6-847703-00 Rev. C00
Installation
11. Each header segment is shipped with a
header bracket. Each header bracket should
be attached to a manifold stand by attaching a
post base to one end of 66-inch channel as
shown in Figure 12, Detail A. Use two each
3/8” bolts, flat washers, and channel nuts.
Tighten all bolts.
12. Set header stand in a vertical position roughly
in alignment with two vertical control panel
stands. Position header bracket against
channel and on bottom side of header as
shown in Figure 5. Attach bracket to channel
as shown in Figure 12, Detail E. Use two
each 3/8” bolts, flat washers, and channel
nuts. Tighten all bolts.
13. Align header stand with two control panel
vertical stands, centering header bracket
between two pigtail connections. Mark
location of all four base mounting holes. Move
header stand aside and drill holes. Minimum
3/8” diameter mounting bolts are
recommended (by others).
14. Reposition header stand over holes and install
mounting hardware (by others). Tighten all
mounting bolts.
15. Assemble u-bolt and bracket hardware as
shown in Figure 5. Tighten u-bolt nuts.
16. Additional header extensions may be
assembled end to end if required.
17. Install large nut and plug removed in step 10
on end of last header extension.
8. Attach 12-inch channel to top of one vertical
channel as shown in Figure 12, Detail D. 12-
inch channel is used to mount power supply
and may be located on either side of manifold
control panel. Use flat plate, four each 3/8"
bolts, flat washers and channel nuts. Unlike
other hardware shown in Figure 12, 3/8 bolts
will pass through elongated holes in back of
channel and will be secured with channel nuts
inside. Tighten all four bolts.
9. Hang manifold control panel on mounting
bracket. Top two control panel mounting bolts
will slide into the slots of bracket. Bottom of
control panel should be angled away from
bracket until top two bolts have been inserted
as shown in Figure 3. Bottom of manifold
control panel can then be positioned toward
bracket so 3/8" mounting stud passes through
lower hole in mounting bracket. Install and
tighten 3/8" nut removed in step 2.
10. Additional shipping cartons contain header
extensions and wall brackets. Depending on
number of cylinders, header extensions are
configured with two or three cylinder inlets.
Large manifold systems may also include
combinations and multiples of each type of
header extension. Remove large nut and plug
from right manifold inlet. Attach appropriate
header extension to right side of manifold
control panel. Position cylinder inlet
connections of each header extension so they
are pointing out (away from wall) and tighten
header extension (Figure 4).
CAUTION:
Do not use thread sealant on header or pigtail
connections.
WARNING:
Do not attempt to lift manifold alone. Two people
are recommended in order to hang manifold onto
wall mounting bracket.
Floor Mounting Manifold Control
