User’s Manual
41/73
Ver. [E.1.1]
(4)
An IP address of the accounting server should be written into the menu of
“Accounting Server IP1”. The Port number that is associated with the accounting
server should be input into this menu. The default value is 1813.
(5)
The “Shared Secret” is a text string that serves as a password, registered at the
accounting server. It must be the same “Shared Secret” between the accounting
server and the DosaLink – 540.
(6)
This menu is for the second authentication server, accounting server, port
numbers, and shared secrets. If there is not a second choice, then it may be
blanked.
(7)
In the “RETRY_PRIMARY_INTERVAL” the time interval when it is requested to
connect to the second authentication server after failing to authenticate from the
first authentication server is established in the case of using a couple of
authentication servers.
(8)
The time from failing to authenticate to requesting to reauthenticate is set in this
menu of “ACCT_INTERIM_INTERVAL”.
(9)
WEB_REDIRECTION: Select to use the Web Redirection function in this menu.
(10)
WEB_REDIRECTION_IP: Input the IP address of Web site that is to be
connected automatically when IEEE 802.1x authentication is failed.
The function of Web Redirection is associated with MD5 of IEEE 802.1x.
When the function of Web Redirection is activated, the message for re-booting
the DosaLink – 540 appears. Click “OK” to re-boot the DosaLink – 540. After this,
the function of Web Redirection can be used.
11.13. Wi-Fi
Protected
Access
(WPA)/ WPA2 (IEEE 802.11i)
The DosaLink – 540 is offered the following two modes:
WPA and WPA2: It is associated with IEEE 802.1x so that the user’s PC is
authenticated and its keys are distributed to the authenticated user’s PC. The
Radius Authetication Server is needed and either the EAP-TLS or the EAP-
TTLS, are used to authenticate.
WPA-PSK and WPA2-PSK: The Pre-Shared Key (PSK) mode is not used
that Radius Authentication Server and associated with IEEE 802.1x. The PSK
that is formed, either 256 bits – 64 hexadecimal or 32 alphanumeric
characters, is inputed directly by a user.
