BBS IPS 308, Руководство пользователя

Страница: 52 / 166

47
The system Flash signal is set at a default value of 480 ms. This default value should work
with most signaling requirement. If not, the timing duration of this signal may be changed
to work with the requirements suggested by the Central Of
fi ce for the features that they may
provide in your area. (see “Switch-hook (Flash) Timing”, page 94)
6. How do you want the incoming lines to ring ?
All incoming CO lines will ring into the system. This step is used to select the manner in
which you wish them to ring according to the use of the desired CO line. For each line, you
can choose to con
fi gure it to handle incoming calls according to the Standard Incoming Line
con fi guration or you can con fi gure it to be a Private Incoming Line.
7. Do you want the unit to automatically detect incoming FAXes ?
Each CO line can have an assigned FAX extension to allow the system to automatically
direct an incoming fax (when the fax tone is detected) to an extension where a fax machine is
connected. The CO line must be in the DISA mode to allow automatic FAX detection.
Dialing “9” To Access Outside Lines
The system is preset so that users dial “9” to access an outside line and dial “0” to make an
intercom call to the Operator. You may want to change the “9” to a “0” if this is the standard in
your area.
Note: If you confi gure the system so that “0” accesses an outside line, “9” will then directly dial the
operator. If “9” is the number for outside line access, then “0” will dial the operator.
7801
To access an outside line by dialing “0”:
In the programming mode, lift the handset, enter “7801”.
Pause for con
fi rmation tone. Hang up or continue programming.
To access an outside line by dialing “9”:
In the programming mode, lift the handset, enter “7800”.
Pause for con
fi rmation tone. Hang up or continue programming.
7800
Central Offi ce Lines- Programming
Chapter 3 - Functions Of IPS System