bbraun 8717070, Руководство по обслуживанию

Страница: 56 / 106

3 Disassembly / Assembly
3 - 24 Infusomat® compact
plus
P 1.0 EN
For internal use, only
5. Disconnect the connectors of the following components on the
sensor board:
a) Pressure sensor, upstream (
Fig. 3 - 31 / Item 1 ).
b) Pressure sensor, downstream ( Fig. 3 - 31 / Item 3 ).
c) SHK motor ( Fig. 3 - 31 / Item 4 ).
6. Completely unlock the connectors of the following components
and pull out the ribbon cable:
a) Pump (
Fig. 3 - 31 / Item 2 ).
b) SHK PCB ICPP ( Fig. 3 - 31 / Item 5 ).
c) Air sensor ( Fig. 3 - 31 / Item 6 ).
7. Push the movable Hall sensor ( Fig. 3 - 32 / Item 2 ) approx. half
the way towards the interior of the unit until it is released from
the bracket (
Fig. 3 - 32 / Item 3 ).
8. Remove two screws ( Fig. 3 - 32 / Item 4 ) using a 15IP TORX
plus screwdriver.
9. Take the sensor board ( Fig. 3 - 32 / Item 1 ) out of the housing
front from above.
Fig. 3 - 31
1 Connector of pressure sensor, upstream
2 Connector of pump
3 Connector of pressure sensor, downstream
4 Connector of SHK motor
5 Connector of SHK PCB ICPP
6 Connector of air sensor
1 2 3 4 5 6
Fig. 3 - 32
1 Sensor board
2 Hall sensor
3 Bracket for Hall sensor
4 Screw DELTA PT 35x10 WN 5451
4
1
2
3
NOTICE
Make sure not to damage the Hall sensor ( Fig. 3 - 32 / Item 2 )
when removing the sensor board.