6
C607215 - GB
INSTRUCTIONS FOR USERS
3.4 AMBIENT TEMPERATURE AND DHW TEMPERATURE ADJUSTMENT
Adjust the ambient temperature (
) and the DHW temperature (
), buttons (figure 1).
The ignition of the burner is shown on the display with the symbol ( ) as described in section 3.1.
HEATING
While the boiler is operating in the heating mode, the display shows the symbol ( ) and the ambient temperature (°C) (see
figure 1).
During manual ambient temperature adjustment, the display shows “
AMB
”.
DOMESTIC HOT WATER
While the boiler is operating in the DHW mode, the display shows the symbol ( ) and the ambient temperature (°C) (see
figure 1). During manual DHW temperature adjustment, the display shows the “
HW SP
”.
NOTE
:
If a storage boiler is connected, while the boiler is operating in the DHW mode, the display shows the symbol
( )
and the ambient
temperature (°C)..
3.4.1. Climate controller installed in the boiler
If the climate controller is installed in the boiler, press
+/-
to adjust the delivery temperature of the heating system water.
The temperature displayed is the ambient temperature.
DATE-TIME SETTINGS
Press
IP
: the display shows
PROG
(for a few seconds) and the hour starts flashing.
NOTE:
if no button is pressed, the function automatically stops after about 1 minute.
3.5 PROGRAMMING (PROG)
• Press
+/-
to adjust the hours;
• Press OK;
• Press
+/-
to adjust the minutes;
• Press OK;
• Press
+/-
to set the day of the week “
Day
”
(1…7 corresponding to Monday…Sunday);
Press
IP
to exit DATE-TIME settings.
To enable hourly programming in the heating mode, press
(the symbol appears on the climate controller display).
Hourly programming allows you to set the automatic boiler operation in the heating mode during determined time
bands and determined days of the week.
Boiler settings can be made for
single
days or for
groups
of consecutive days.
3.6.1. Single days
4 time bands are available every day (4 boiler switching on and switching off cycles in the heating mode, with times that can differ
from day to day), as indicated in the following table:
3.6 HOURLY PROGRAMMING IN HEATING MODE
