Baxi LINA 3 COMFORT HT, Инструкция по эксплуатации

Страница: 57 / 384

57
926.420.3 - EN
INSTRUCTIONS FOR USERS
All the faults are displayed in order of importance; if more than one fault occurs at the same time, the first to be displayed
is the one with higher priority. After eliminating the reasons for the first fault, the second will be displayed, and so on.
If a certain fault occurs frequently, contact the Authorised Service Centre.
9.1 TABLE OF FREQUENT MESSAGES AND FAULTS SHOWN ON THE DISPLAY
To keep the boiler efficient and safe, have it checked by the authorised Service Centre at the end of every operating pe-
riod.
Careful servicing ensures economical operation of the system.
Do not clean the outer casing of the appliance with abrasive, aggressive and/or easily flammable cleaners (e.g.: petrol,
alcohol, and so on). Always switch off the appliance before cleaning it (see section 5 Switching off the boiler).
10. ROUTINE MAINTENANCE INSTRUCTIONS
Error
code
Description of fault Corrective action
10E
External probe sensor faulty Call the Authorised Service Centre.
20E NTC delivery sensor faulty Call the Authorised Service Centre.
28E NTC fumes sensor faulty Call the Authorised Service Centre.
50E NTC domestic hot water sensor faulty Call the Authorised Service Centre.
60E Ambient probe faulty Call the Authorised Service Centre.
62E Electronic board software version obsolete Call the Authorised Service Centre.
88E
Communication error between board and AVS 77 climate
controller
Call the Authorised Service Centre.
95E AVS 77 climate controller clock faulty Call the Authorised Service Centre.
110E Safety thermostat tripped
Press “OK” twice to reset (figure 1). If this fault persists, call the
Authorised Service Centre.
119E
Hydraulic pressure switch block
Check that the pressure in the system is correct; See section
on filling the boiler. If this fault persists, call the Authorised
Service Centre..
125E No water in system or Air in system
Press
“OK”
twice to reset (figure 1). If this fault persists, call the
Authorised Service Centre.
127E “Anti-legionellosis” function enabled
The signal is temporary and finishes automatically when the
function terminates.
130E Fumes NTC tripped due to overtemperature
Press
“OK”
” twice to reset (figure 1). If this fault persists, call
the Authorised Service Centre.
131E
Electricity has been disconnected from the boiler fol-
lowing fault E125 or E130.
Press
“OK”
twice to reset (figure 1). If this fault persists, call the
Authorised Service Centre.
133E No gas
Press “OK” twice to reset (figure 1). If this fault persists, call the
Authorised Service Centre.
151E Internal boiler card error
Call the Authorised Service Centre. Check the position of the
ignition electrodes (section 24).
155E Exceeded max. n° of Reset attempts (n° 5) Press the “RESET” button on the boiler (figure 4).
156E
Input voltage too low
Wait for input voltage to return to normal values. The programme
is reset automatically.
160E Fan speed threshold not reached Call the Authorised Service Centre.
193E Air in circuit
This fault signal is temporary. Reset is performed automati-
cally.